Products NEEDED
24" 18-gauge sterling silver wire
Pre-made sterling silver cuff bracelet
(You may make your own cuff bracelet from hefty
gauge sterling silver rectangle wire if you like.)
Instruments Required
Liver of sulfur or oxidizing Answer
Ruler
Marker
Round nose pliers Wire cutters or tin snips File
Chain nose pliers Great steel wool Polishing cloth Basic safety Eyeglasses
one. Apply liver of sulfur or oxidizing Remedy to your 24" of eighteen-gauge sterling silver wire.
It is vital to observe any basic safety tips the company implies around the Instructions when dealing with any chemicals. You are going to use the fantastic steel wool about the oxidized wire to remove several of the darkened regions When you comprehensive the wrapping course of action.
2.Use the ruler to measure and mark the 24" of 18-gauge wire into 4 sections. Evaluate and mark the wire at 7", twelve*. and seventeen".
three.Upcoming, measure and mark the center of the top from the cuff bracelet (as it’s curved, you may just form of eyeball it). Then make use of the ruler to measure and mark %" from the center from the cuff to either side.
4.Firmly grasp the marked center of your 24" 18-gauge wire inside the jaws in the spherical nose pliers. Make use of your fingers to bend the sides all the way down to sort an upside-down U form (the wire will resemble a big bobby pin).
When working with extensive parts of wire, security Eyeglasses are encouraged.
5.Slide the wire on to the sterling silver cuff bracelet to the center mark. Pinch the wire tight on to the cuff bracelet and, when Keeping the wire about the cuff along with your fingers, wrap one facet on the wire randomly towards the Vi' mark that you just produced on the best from the cuff bracelet. You'll want to watch where by the 7" as well as 17' marks are to the wire and use them to match up Along with the Vi" mark which you made to the cuff bracelet.
eight. Make use of the spherical nose pliers to curl the ends with the wire up into your wrapped wire about the underside of your cuff bracelet. Use the chain nose pliers to firmly κοσμήματα φθηνά squeeze the finally ends up into one other wrapped wire. This will likely continue to keep the finishes securely in place.
6.End wrapping the wire on one other side, matching up the seven" and the 17" marks about the cuff bracelet While using the Vi" marks within the 18-gauge wire.
seven.Now wrap the wire on one κολιΠόνομα aspect again towards the middle from the cuff bracelet. Then wrap the wire on the other aspect of your cuff bracelet again toward the center. You may have to trim and file the ΑνδÏικά δαχτυλίδια ends with the wire so they finish up around the backside from the cuff bracelet.
9. Use good steel wool to get rid of the darkened place on the surface in the wire, leaving the places from the crevices with the wrapped wire darkish. μονόπετÏα μπÏιγιάν τιμÎÏ‚ Buff the wrapped wire plus the cuff bracelet with a polishing cloth.
What suggestions would you give you a starting artist?
Λ portrait teacher when advised me that because of the 500th portrait I could well be really great. Lesson-apply; practice everyday.
Keep on with just one medium and get it done very well. Craftsmanship is key.
This cuff is great for Males as well as women. Use the larger men's sizing of pre-designed cuff bracelet and insert further δαχτυλίδια μπÏιγιάν size towards the 18-gauge sterling silver wire, generally 6 to eight inches to accommodate
the larger men’s cuff bracelet.
